Who should select the specific welds for NDT to cover the 10% contractual percentage required by the specification/Code?

Who has the responsibility of ensuring the welder is using the correct polarity during welding?

In a welding procedure transverse joint tensile test the following observations were made. The specimen CSA was recorded as 30 mm X 20mm and the maximum load applied was recorded a

In a welding procedure transverse joint tensile test the following observations were made. The specimen CSA wa...

Charpy impact tests showing a rough torn surface after the completed test would indicate which type of failure?

Which of the following is NOT a quantitative test?

When transverse tensile testing a welded joint excess weld metal is often removed. This action is done to:

In an all weld tensile test, the original specimen gauge length was 50 mm and after the test the increased gauge length was 65 mm. What is the elongation percentage?

Which of the following information should the welding inspector enter on an electrode vacuum pack at the point of breaking the vacuum?

In welder qualification testing of 10 mm plates, 2 root and 2 face bends were tested. 1 root bend failed what course of action would you follow?

An STRA test is carried out to determine which of the following?

Charpy impact test shows a 50% rough torn surface and a 50% flat crystalline surface after completed test, this would indicate which type of failure?

Which of the following defects are unlikely to be detected by normal radiographic techniques?