AskChainX

From examination of the fracture faces, a ductile failure can be identified by:

A code gives the acceptance standard for excess weld metal “h” as h > 1 mm + 0.1b, max. 5 mm; where “b” is the width of the weld cap. For which of the following situations is the e

A code gives the acceptance standard for excess weld metal “h” as h > 1 mm + 0.1b, max. 5 mm; where “b” is the...

Which welding parameter has the greatest influence on heat input?

A fillet weld has a design throat thickness of 8 mm. What is the minimum leg length that is required?

In a martensite grain structure, which of the following mechanical properties would be increased?

Which of the following alloying elements is used to improve the toughness of steel?

For MIG/MAG Welding, wire feed speed is proportional to:

A typical temperature for stress relieving carbon-manganese steel weldments is:

A brittle fracture can be identified (from examination of the fracture faces) by:

Which of the following statements about lamellar tearing is correct ?

When all weld imperfections have been located, it is mandatory that:

Which of the following is non-magnetic?