AskChainX

According to BS EN 22553, symbol designation Z is used to represent

If the torch was trailing when using the MIG/MAG process. Which of the following appearance of the weld is most likely to be observed during visual inspection?

Which tungsten electrode is usually used to weld Aluminium?

Is it always necessary to preheat the base material before welding?

In MIG/MAG welding what would be affected if the CTWD was increased?

A butt weld was produced in a 40 mm steel plate. The electrode type was basic and the diameter 4mm. The welding parameters used for one of the welding runs were 190 ampere, 24 volt

A butt weld was produced in a 40 mm steel plate. The electrode type was basic and the diameter 4mm. The weldin...

In MIG/MAG welding which mode of transfer is referred to as non-desired?

Cathodic cleaning is used to remove?

What is the main purpose of the pre and post flow function on a TIG welding machine?

What is an essential variable?

Why are welding procedures produced? To check

A main element involved in solidification cracking is