AskChainX Admin

Weld decay can be minimized by specifying a steel with

Weld decay cause which of the following problem

The temperature at which chromium carbide is formed is in the range

When examining a completed bend test, the angle of the bend was found to be 185°. The testing specification calls for the sample to have been formed through 180°

When using multiple SAW arc systems (twin wires etc.), the arc often has different polarities or use all AC rather than DC polarity. This is to

When MMA welding what will be the effect on the weld if the power source was changed from AC to DC -ve?

What is a typical ARC voltage setting when welding with TIG (GTAW) process in AC?

A butt weld has been made by MMA in a 50 thick impact tested steel plate. The welding electrode used was a basic type 5mm diameter, the measured running parameters for one run was

A butt weld has been made by MMA in a 50 thick impact tested steel plate. The welding electrode used was a bas...

Charpy impact test showing rough torn surface after the completed test, this would indicate which type of failure

In a cross joint tensile test, the following observations were made; specimen width: 20mm, material thickness: 20mm, max load 180KN, break position: parent plate. What is the UTS?

Who determines what the correct preparation (root gap, root face, included angle) should be?

What is the recommended minimum range of illumination required by BS EN 970 for inspection of a welded surface?